Open Access
Ordered titanium dioxide nanotubes for lossy-mode resonance-based humidity sensing
(Optica Publishing Group, 2022) Pitula, Emil; Kouao, Dujearic-Stephane; Grochowska, Katarzyna; Sezemsky, Petr; Simerova, Radka; Domínguez Rodríguez, Ismel; Siuzdak, Katarzyna; Del Villar, Ignacio; Stranak, Vitezslav; Smietana, Mateusz; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
Ordered titanium dioxide nanotubes on indium tin oxide as a structure supporting lossy-mode resonance is reported. Capability for application of the structure for optical humidity sensing is shown as an application example.
Open Access
Multichannel refractometer based on lossy mode resonances
(IEEE, 2022) Fuentes Lorenzo, Omar; Corres Sanz, Jesús María; Domínguez Rodríguez, Ismel; Del Villar, Ignacio; Matías Maestro, Ignacio; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
In this work a new multiparameter sensor platform based on lossy mode resonances is presented. The structure consists of a soda-lime optical slab waveguide butt-coupled to multimode optical fibers. A variable thickness thin-film is deposited to generate multiple independent resonances on the same waveguide, which can be monitored using a single spectrometer. In order to show the potentiality of the structure, a broad resonance was selectively narrowed by etching sections of the LMR producer thin film. The spectral width is progressively reduced, allowing to selectively isolate independent resonances, which opens the path for multiple LMR generation in the same spectra in a multiparameter sensing platform. The experimental results were corroborated with a theoretical analysis based on the finite difference method (FDM). As a proof of concept, two refractometers on the same waveguide were fabricated and tested using PDMS cells. This platform can be easily miniaturized in order to integrate multiple sensors at low cost, what can be of interest for the development of multi-analyte biosensors probes. IEEE
Open Access
Spectral measurements with hybrid LMR and SAW platform for dual parameter sensing
(Royal Society of Chemistry, 2022) Domínguez Rodríguez, Ismel; Del Villar, Ignacio; Corres Sanz, Jesús María; Lachaud, Jean-Luc; Yang, Yang; Hallil, Hamida; Dejous, Corinne; Matías Maestro, Ignacio; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Lossy mode resonance (LMR)-based optical sensors change their wavelength upon contact with substances or gases. This allows developing applications to detect the refractive index of the surrounding medium and even the thickness of the biolayers deposited on the waveguide. In the same way, when acoustic sensors are in contact with a liquid, it is possible to determine parameters, especially mechanical ones such as shape of the particle or molecule, mass load, elastic constants and viscosity of the liquid. This work reports the development of a system that combines LMR with surface acoustic wave (SAW) technologies to characterize a liquid in terms of its refractive index and viscosity simultaneously. Conveniently prepared glucose solutions are used for sensor calibration. The refractive index of the solutions ranges from 1.33 to 1.41 and its viscosity ranges from 1.005 mPa·s to 9 mPa·s, respectively. A sensitivity of 332 nm per RIU has been achieved with the optical sensor while the acoustic sensor has shown a sensitivity of −1.5 dB/(mPa·s). This new combinational concept could be expanded to the development of more demanding applications such as chemical sensors or biosensors.
Open Access
Mode transitions and thickness measurements during deposition of nanoscale TiO2 coatings on tilted fiber Bragg gratings
(IEEE, 2022) Imas González, José Javier; Albert, Jacques; Del Villar, Ignacio; Ozcariz Celaya, Aritz; Ruiz Zamarreño, Carlos; Matías Maestro, Ignacio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
The mode transition is a phenomenon observed in thin film coated long period fiber gratings (LPGs) and singlemode multimode single-mode (SMS) fibers for certain values of the coating thickness and refractive index, resulting in increased sensitivity for sensing applications. It is shown here that mode transitions occur simultaneously for a large number of mode resonances in the transmission spectra of tilted fiber Bragg gratings (TFBG) measured during the deposition of ~350nm thick TiO2 coatings by Atomic Layer Deposition (ALD). In TFBGs, the mode transition shows up as an acceleration of the resonance wavelength shift vs thickness, but without fading of the resonance amplitude. Furthermore, the results show that the mode transition for cladding modes with predominantly “TE” polarization at the cladding boundary is significantly sharper than that of predominantly “TM” polarized modes and that it occurs at a smaller coating thickness (<100 nm vs >200 nm). Finally, using a separately determined coating refractive index (2.14, by ellipsometry on witness flats deposited simultaneously) and simulations of the resonance shifts of the TFBG with coating thickness, it is demonstrated that a TFBG connected to a spectral interrogation system can be used to measure the growth of a coating on the surface of the fiber in real time.
Open Access
Lossy mode resonance based microfluidic platform developed on planar waveguide for biosensing applications
(MDPI, 2022) Benítez Pérez, Melanys; Zubiate Orzanco, Pablo; Del Villar, Ignacio; Socorro Leránoz, Abián Bentor; Matías Maestro, Ignacio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
The development of resonance phenomena-based optical biosensors has gained relevance in recent years due to the excellent optical fiber properties and progress in the research on materials and techniques that allow resonance generation. However, for lossy mode resonance (LMR)-based sensors, the optical fiber presents disadvantages, such as the need for splicing the sensor head and the complex polarization control. To avoid these issues, planar waveguides such as coverslips are easier to handle, cost-effective, and more robust structures. In this work, a microfluidic LMR-based planar waveguide platform was proposed, and its use for biosensing applications was evaluated by detecting anti-immunoglobulin G (anti-IgG). In order to generate the wavelength resonance, the sensor surface was coated with a titanium dioxide (TiO2) thin-film. IgG antibodies were immobilized by covalent binding, and the detection assay was carried out by injecting anti-IgG in PBS buffer solutions from 5 to 20 μg/mL. The LMR wavelength shifted to higher values when increasing the analyte concentration, which means that the proposed system was able to detect the IgG/anti-IgG binding. The calibration curve was built from the experimental data obtained in three repetitions of the assay. In this way, a prototype of an LMR-based biosensing microfluidic platform developed on planar substrates was obtained for the first time
Open Access
Ultrahigh sensitive detection of tau protein as Alzheimer's biomarker via microfluidics and nanofunctionalized optical fiber sensors
(Wiley, 2022) Chiavaioli, Francesco; Santano Rivero, Desiree; Del Villar, Ignacio; Socorro Leránoz, Abián Bentor; Zhang, Xuejun; Li, Kaiwei; Santamaría Martínez, Enrique; Fernández Irigoyen, Joaquín; Baldini, Francesco; Van den Hove, Daniel L. A.; Shi, Lei; Bi, Wei; Guo, Tuan; Giannetti, Ambra; Matías Maestro, Ignacio; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Alzheimer’s disease (AD) is one of the most common neurodegenerative illnesses displaying the highest death rate in the elderly. However, the existing AD diagnostic system remains elusive due to lack of a technology that may ensure enough sensitivity and reproducibility, detection accuracy, and specificity. Herein, a straightforward approach is reported to realize lab-on-fiber (LoF) technology for AD biomarker detection based on a D-shaped single-mode fiber combined with nanometer-scale metal-oxide film. The proposed sensing system, which permits the generation of lossy-mode resonance (LMR), remarkably increases the evanescent field of light guided through the fiber, and hence the fiber-surrounding medium interaction. Moreover, such optical sensors are highly repeatable in results and can safely be embedded into a compact and stable microfluidic system. Herein, the specific detection of Tau protein (as one of the classical AD biomarkers that is highly correlated with AD progression) in a complex biofluid with a detection limit of 10 12 M and over a wide concentration range (10 3 –10 μg mL 1 ) is successfully demonstrated. The proposed LoF biosensor is an appealing solution for rapid, sub-microliter dose and highly sensitive detection of analytes at low concentrations, hereby having the potential toward early screening and personalized medicine in AD.
Open Access
Tunable sensitivity in long period fiber gratings during mode transition with low refractive index intermediate layer
(IEEE, 2022) Del Villar, Ignacio; Montoya-Cardona, Jorge; Imas González, José Javier; Reyes-Vera, Erick; Ruiz Zamarreño, Carlos; Matías Maestro, Ignacio; Cruz, José Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
Double-clad fibers where the second cladding has a lower refractive index than the first cladding, prove to be ideal structures for potentiating and tuning the sensitivity in long-period fiber gratings (LPFGs) operating in mode transition. When a thin film is deposited on the optical fiber, the second cladding performs acts as a barrier that initially prevents the transition to guidance in the thin film of one of the modes guided in the first cladding. Finally, the transition to guidance occurs with a sensitivity increase, in analogy to the tunnel effect observed in semiconductors. This improvement has been demonstrated both as a function of the thin film thickness and the surrounding medium refractive index, with enhancement factors of 4 and 2, respectively. This idea reinforces the performance of LPFGs, adding a new degree of freedom to the mode transition and the dispersion turning point phenomena. Moreover, the control of the variation of the effective index of cladding modes could be applied in other structures, such as tilted-fiber gratings or evanescent wave sensors.
Open Access
Mode transition during deposition of nanoscale ITO coatings on tilted fiber Bragg gratings
(Optica Publishing Group, 2022) Imas González, José Javier; Albert, Jacques; Del Villar, Ignacio; Ozcariz Celaya, Aritz; Ruiz Zamarreño, Carlos; Matías Maestro, Ignacio; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
The mode transition phenomenon is experimentally demonstrated in tilted fiber Bragg gratings (TFBG) through the deposition of an indium tin oxide (ITO) thin film employing a DC sputtering machine.
Open Access
Learning CAN bus communication with a remote laboratory
(IEEE, 2022) Del Villar, Ignacio; Rodriguez-Gil, Luis; Orduña, Pablo; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
CAN bus is a very important communications protocol. Its usage is extended to many applications and it is key to know some fundamentals in an introductory course to industrial communications. A collaborative experience between the Public University of Navarra has permitted students of Industrial Technologies Engineering and Electrical and Electronic Engineering to access a remote laboratory where they can progress in the development of a project where they must implement a CAN bus client and server for monitoring the parameters of a vehicle. More than twenty parameters can be monitored and the remote laboratory is 24 hours a day accessible, which permits students to work at home and progress more in the multiprotocol project they develop at the university. The interface and some code examples are shown, along with some statistics that demonstrate the utilization of the tool by the students with the aid of some evaluation measurements taken by the lecturer. Finally, a survey was performed to the students in order to understand better the potential of the remote laboratory assisted teaching as well as to know where to improve it in the next future.
Open Access
Bloch surface wave resonances generated with dielectric stack of high refractive index contrast deposited on a D-shaped optical fiber for sensing applications
(Optica Publishing Group, 2022) Del Villar, Ignacio; Kwietniewski, Norbert; González-Valencia, Esteban; Burnat, Dariusz; Armas, Dayron; Pitula, Emil; Matías Maestro, Ignacio; Chiavaioli, Francesco; Torres, Pedro; Smietana, Mateusz; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A 5-layer stack composed of TiO2 and Al2O3, two materials with a high refractive index contrast, was deposited on a D-shaped fiber to generate Bloch surface wave resonances with an improved figure of merit.