Open Access
Mode transition during deposition of nanoscale ITO coatings on tilted fiber Bragg gratings
(Optica Publishing Group, 2022) Imas González, José Javier; Albert, Jacques; Del Villar, Ignacio; Ozcariz Celaya, Aritz; Ruiz Zamarreño, Carlos; Matías Maestro, Ignacio; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
The mode transition phenomenon is experimentally demonstrated in tilted fiber Bragg gratings (TFBG) through the deposition of an indium tin oxide (ITO) thin film employing a DC sputtering machine.
Open Access
Lossy mode resonance-based sensors in planar configuration: a review
(IEEE, 2023) Matías Maestro, Ignacio; Del Villar, Ignacio; Corres Sanz, Jesús María; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
Lossy mode resonance (LMR)-based sensors have attracted much interest during the last decade in the domain of optical fiber (OF). Here, it is shown that the progress made in the transfer of this technology to planar waveguides (PWs) with different sensing applications such as environmental sensors and biosensors. In addition, the inherent advantages in terms of robustness, simplicity, and easiness to generate novel complex structures are discussed.
Open Access
Low cutoff wavelength etched SMS structures towards verification of the quality of automotive antifreeze
(IEEE, 2020) Rodríguez Rodríguez, Wenceslao Eduardo; Rodríguez Rodríguez, Adolfo Josué; Ruiz Zamarreño, Carlos; Del Villar, Ignacio; Zúñiga Alanís, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Gobierno de Navarra / Nafarroako Gobernua, 2019 904 116; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA26
Optical fiber single mode-multimode-single mode (SMS) structures can be used as wavelength detection-based sensors. In this work, we focus on the performance at short wavelengths, where optical sources and detectors are less expensive. Here, a self-image band with a high transmission power is monitored in this short-wavelength range. In addition, the diameter and the length of the SMS structure have been optimized in order to improve the sensitivity of the device. In this sense, a maximum refractive index sensitivity of 305 nm/RIU was achieved by an etched SMS with a diameter of 34μ m. Furthermore, the obtained devices were used for testing the quality of automotive coolant and antifreeze liquid.
Open Access
Twin lossy mode resonance on a single D-shaped optical fiber
(Optica, 2021) Imas González, José Javier; Ruiz Zamarreño, Carlos; Del Villar, Ignacio; Pérez Escudero, José Manuel; Matías Maestro, Ignacio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
This letter presents the fabrication of dual lossy mode resonance (LMR) refractometers based on titanium dioxide (TiO2) and tin oxide (SnO2) thin films deposited on a single side-polished D-shaped optical fiber. For the first time, to the best of our knowledge, two independent LMRs are obtained in the same D-shaped optical fiber, by using a step-shaped nanostructure consisting of a first section of TiO2 with a thickness of 120 nm and a second section with a thickness of 140 nm (120 nm of TiO2 and 20 nm of SnO2). Each section is responsible for generating a first-order LMR with TM-polarized light (LMRTM). TiO2 is deposited by atomic layer deposition and SnO2 by electron-beam deposition. The theoretical results show that the depth of each of the resonances of the dual LMR depends on the length of the corresponding section. Two experimental devices were fabricated with sections of different lengths, and their sensitivities were studied, achieving values ∼ 4000 nm/refractive index unit (RIU) with a maximum of 4506 nm/RIU for values of the SRI between 1.3327 and 1.3485.
Open Access
Albumin-based optical and electrochemical biosensors for PFAS detection: a comparison
(Springer, 2023) Moro, G.; Chiavaioli, Francesco; Zubiate Orzanco, Pablo; Del Villar, Ignacio; Baldini, Francesco; De Wael, K.; Moretto, L. M.; Giannetti, Ambra; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
The widespread industrial use of per- and polyfluoroalkyl substances (PFAS) have engendered the release of these manmade chemicals in the environment with harmful effects on animal and human health. To monitor PFAS levels in drinking waters, sensitive and versatile sensing strategies are urgently required. Since many perfluoroalkyl carboxylic acids, such as perfluorooctanoic acid (PFOA), are fatty acid-mimic, delipidated human serum albumin (HSA) can be applied as biorecognition element for the design of novel PFAS sensors. Here, two albumin-based biosensing strategies are described and compared: i) a lossy mode resonance (LMR) fiber optic one and ii) an impedimetric portable one developed on screen-printed electrodes. In both biosensing platforms, HSA was covalently immobilized via EDC/NHS chemistry using the carboxylic moieties of the polymeric layers previously deposited at the transducer surface. Afterwards, the conformational changes related to the formation of HSA/PFOA complex were followed considering: i) the LMR spectral shifts for the optical platform and ii) the changes of absolute impedance for the impedimetric one. The performance and future developments of both PFOA biosensors are discussed.
Open Access
Surface exciton polariton resonances (SEPR)-based sensors
(Elsevier, 2023) Vitoria Pascual, Ignacio; Ruiz Zamarreño, Carlos; Ozcariz Celaya, Aritz; Imas González, José Javier; Del Villar, Ignacio; Matías Maestro, Ignacio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
A new type of resonance in the development of sensors using long-range surface exciton polariton (LRSEP) phenomena has been coined: surface exciton plasmon resonance (SEPR). The resonance was obtained in the reflected spectrum of a Kretschmann-Raether setup with a two-coupled-interface structure composed of 412 nm magnesium fluoride and 50 nm chromium thin films. The roles of different parameters such as thicknesses of the films and the incidence angles have been simulated. Some preliminary experimental results show a promising performance with a shift of the resonance central wavelength with changes in the incidence angle of -136.52 nm/° and a sensitivity of 23,221 nm/refractive index unit.
Open Access
Spectral measurements with hybrid LMR and SAW platform for dual parameter sensing
(Royal Society of Chemistry, 2022) Domínguez Rodríguez, Ismel; Del Villar, Ignacio; Corres Sanz, Jesús María; Lachaud, Jean-Luc; Yang, Yang; Hallil, Hamida; Dejous, Corinne; Matías Maestro, Ignacio; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Lossy mode resonance (LMR)-based optical sensors change their wavelength upon contact with substances or gases. This allows developing applications to detect the refractive index of the surrounding medium and even the thickness of the biolayers deposited on the waveguide. In the same way, when acoustic sensors are in contact with a liquid, it is possible to determine parameters, especially mechanical ones such as shape of the particle or molecule, mass load, elastic constants and viscosity of the liquid. This work reports the development of a system that combines LMR with surface acoustic wave (SAW) technologies to characterize a liquid in terms of its refractive index and viscosity simultaneously. Conveniently prepared glucose solutions are used for sensor calibration. The refractive index of the solutions ranges from 1.33 to 1.41 and its viscosity ranges from 1.005 mPa·s to 9 mPa·s, respectively. A sensitivity of 332 nm per RIU has been achieved with the optical sensor while the acoustic sensor has shown a sensitivity of −1.5 dB/(mPa·s). This new combinational concept could be expanded to the development of more demanding applications such as chemical sensors or biosensors.
Open Access
Generation of lossy mode resonances with different nanocoatings deposited on coverslips
(Optical Society of America, 2020) Fuentes Lorenzo, Omar; Goicoechea Fernández, Javier; Corres Sanz, Jesús María; Del Villar, Ignacio; Ozcariz Celaya, Aritz; Matías Maestro, Ignacio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
The generation of lossy mode resonances (LMRs) with a setup based on lateral incidence of light in coverslips is a simple platform that can be used for sensing. Here the versatility of this platform is proved by studying the deposition of different coating materials. The devices were characterized with both SEM and AFM microscopy, as well as ellipsometry, which allowed obtaining the main parameters of the coatings (thickness, refractive index and extinction coefficient) and relating them with the different sensitivities to refractive index attained with each material. In this way it was possible to confirm and complete the basic rules observed with lossy mode resonance based optical fiber sensors towards the design of simpler and more compact applications in domains such as chemical sensors or biosensors.
Open Access
Ultrahigh sensitive detection of tau protein as Alzheimer's biomarker via microfluidics and nanofunctionalized optical fiber sensors
(Wiley, 2022) Chiavaioli, Francesco; Santano Rivero, Desiree; Del Villar, Ignacio; Socorro Leránoz, Abián Bentor; Zhang, Xuejun; Li, Kaiwei; Santamaría Martínez, Enrique; Fernández Irigoyen, Joaquín; Baldini, Francesco; Van den Hove, Daniel L. A.; Shi, Lei; Bi, Wei; Guo, Tuan; Giannetti, Ambra; Matías Maestro, Ignacio; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Alzheimer’s disease (AD) is one of the most common neurodegenerative illnesses displaying the highest death rate in the elderly. However, the existing AD diagnostic system remains elusive due to lack of a technology that may ensure enough sensitivity and reproducibility, detection accuracy, and specificity. Herein, a straightforward approach is reported to realize lab-on-fiber (LoF) technology for AD biomarker detection based on a D-shaped single-mode fiber combined with nanometer-scale metal-oxide film. The proposed sensing system, which permits the generation of lossy-mode resonance (LMR), remarkably increases the evanescent field of light guided through the fiber, and hence the fiber-surrounding medium interaction. Moreover, such optical sensors are highly repeatable in results and can safely be embedded into a compact and stable microfluidic system. Herein, the specific detection of Tau protein (as one of the classical AD biomarkers that is highly correlated with AD progression) in a complex biofluid with a detection limit of 10 12 M and over a wide concentration range (10 3 –10 μg mL 1 ) is successfully demonstrated. The proposed LoF biosensor is an appealing solution for rapid, sub-microliter dose and highly sensitive detection of analytes at low concentrations, hereby having the potential toward early screening and personalized medicine in AD.
Open Access
Monitoring of water freeze-thaw cycle by means of an etched single-mode - multimode - single-mode fiber-optic refractometer
(IEEE, 2023) Socorro Leránoz, Abián Bentor; Aginaga Etxamendi, Concepción Isabel; Díaz Lucas, Silvia; Urrutia Azcona, Aitor; Del Villar, Ignacio; Matías Maestro, Ignacio; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
As an alternative to the different technologies that permit the detection of in-situ ice formation on different surfaces, this contribution proposes the design of an etched single-mode – multimode – single-mode (E-SMS) fiber-optic-based structure as a multimode interference refractometer. This sensor provides enhanced properties with respect to a basic SMS structure, including a higher sensitivity and periodical interferometry bands that can measure surrounding refractive indices with repeatability and robustness. Since ice and water refractive indices are sufficiently different, this structure has been used to detect the freezing - thawing process of water taking place inside a freezer between -20°C and +20°C. Also, this work intends to show a proof of concept of a simple technology that can be applied in different situations, such as in smart cities, avionics, structural health monitoring or even to avoid a cold chain breakage. Inside, novel developments to better understand the working operation of the E-SMS structure are shown, together with a study on how to correlate optical and thermal measurements from a refractive index point of view.