Open Access
Study of the degradation of heat exchanger materials in the acidic environment of Teide National Park
(2019) Catalán Ros, Leyre; Pérez Artieda, Miren Gurutze; Berlanga Labari, Carlos; Garacochea Sáenz, Amaia; Rodríguez García, Antonio; Domínguez, Vidal; Montañez, Ana Carolina; Padilla, Germán D.; Pérez, Nemesio M.; Ingeniaritza; Institute for Advanced Materials and Mathematics - INAMAT2; Institute of Smart Cities - ISC; Ingeniería
Supplying power to volcanic monitoring stations constitutes a challenge due to both the access difficulties and the acidic environment associated with volcanoes. ELECTROVOLCAN project is developing thermoelectric generators that make use of the temperature of the available fumaroles to directly supply electricity to the stations in a robust, compact and reliable way. The main element of thermoelectric generators are the thermoelectric modules, based on Seebeck effect. Nonetheless, since the efficiency of these modules increases with the temperature difference between their sides, the introduction of heat exchangers becomes essential. The present study analyses the behavior of different materials used in the construction of the heat exchangers in the acidic environment of Teide National Park.
Open Access
Geothermal thermoelectric generator for Timanfaya National Park
(2019) Catalán Ros, Leyre; Astrain Ulibarrena, David; Aranguren Garacochea, Patricia; Araiz Vega, Miguel; Ingeniaritza; Institute of Smart Cities - ISC; Ingeniería
Despite being one of the largest renewable sources, geothermal energy is not widely utilized for electricity generation. In the case of shallow Hot Dry Rock (HDR) fields, thermoelectric generators can entail a sustainable alternative to Enhanced Geothermal Systems (EGS). The present work studies two configurations of thermoelectric generators for Timanfaya National Park (Spain), one of the most important Hot Dry Rock fields in the world, with temperatures of 500°C at only 3 meters deep. The first configuration includes biphasic thermosyphons as heat exchangers for both sides, leading to a completely passive thermoelectric generator. The second configuration uses fin dissipators as cold-side heat exchangers.
Open Access
The promising combination of thermoelectric generators with IoT technologies for autonomous monitoring systems
(2019) Garacochea Sáenz, Amaia; Catalán Ros, Leyre; Casi Satrústegui, Álvaro; Gubía Villabona, Eugenio; Astrain Ulibarrena, David; Ingeniaritza; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería; Ingeniería Eléctrica, Electrónica y de Comunicación
Monitoring stations becomes essential in any volcanic system in the world but, because of their remote location, both the electricity supply and the communications represent a technological challenge. The present work studies the feasibility of an autonomous volcanic monitoring system powered by thermoelectric generators for one of the monitoring stations of the Teide National Park (Canary Island), where temperatures of 80°C at few centimeters from the surface are found. The stable generation and robustness of thermoelectricity in combination with a new communication system based on LoRa (a low power wireless technology) make this solution a good alternative.
Open Access
Improvements in the cooling capacity and the COP of a transcritical CO 2 refrigeration plant operating with a thermoelectric subcooling system
(Elsevier, 2019) Astrain Ulibarrena, David; Merino Vicente, Amaya; Catalán Ros, Leyre; Aranguren Garacochea, Patricia; Araiz Vega, Miguel; Sánchez, Daniel; Cabello, Ramón; Llopis, R.; Ingeniaritza; Institute of Smart Cities - ISC; Ingeniería
Restrictive environmental regulations are driving the use of CO 2 as working fluid in commercial vapour compression plants due to its ultra-low global warming potential (GWP 100 = 1) and its natural condition. However, at high ambient temperatures transcritical operating conditions are commonly achieved causing low energy efficiencies in refrigeration facilities. To solve this issue, several improvements have been implemented, especially in large centralized plants where ejectors, parallel compressors or subcooler systems, among others, are frequently used. Despite their good results, these measures are not suitable for small-capacity systems due mainly to the cost and the complexity of the system. Accordingly, this work presents a new subcooling system equipped with thermoelectric modules (TESC), which thanks to its simplicity, low cost and easy control, results very suitable for medium and small capacity plants. The developed methodology finds the gas-cooler pressure and the electric voltage supplied to the TESC system that maximizes the overall COP of the plant taking into account the ambient temperature, the number of thermoelectric modules used and the thermal resistance of the heat exchangers included in the TESC. The obtained results reveal that, with 20 thermoelectric modules, an improvement of 20% in terms of COP and of 25.6% regarding the cooling capacity can be obtained compared to the base cycle of CO 2 of a small cooling plant refrigerated by air. Compared to a cycle that uses an internal heat exchanger IHX, the improvements reach 12.2% and 19.5% respectively.
Open Access
The importance of the assembly in thermoelectric generators
(IntechOpen, 2018) Araiz Vega, Miguel; Catalán Ros, Leyre; Herrero Mola, Óscar; Pérez Artieda, Miren Gurutze; Rodríguez García, Antonio; Ingeniaritza; Institute of Smart Cities - ISC; Ingeniería
Generally, in the optimization of thermoelectric generators, only the heat exchangers or the thermoelectric modules themselves are taken into account. However, the assembly of the generator as a whole is of vital importance since a bad contact or a thermal bridge can waste the performance of an optimal generator. In this sense, the present chapter analyzes experimentally the use of different interface materials to reduce the thermal contact resistance between the modules and the heat exchangers, the influence of the pressure distribution in the assembly as well as the effect of different insulating materials in order to reduce the thermal bridge between the exchangers. Thus, it has been demonstrated that a good assembly requires the implementation of thermal interface materials to ensure the microscopic contact between the heat exchangers and the modules, besides a uniform clamping pressure. Nevertheless, since this is normally achieved with screws, they represent a source of thermal bridges in conjunction with the small distance between the exchangers. In order to reduce heat losses due to thermal bridges, which can represent up to one-third of the incoming heat, an increment of the distance between the exchangers and the use of an insulator is recommended.
Open Access
New opportunities for electricity generation in shallow hot dry rock fields: a study of thermoelectric generators with different heat exchangers
(Elsevier, 2019) Catalán Ros, Leyre; Aranguren Garacochea, Patricia; Araiz Vega, Miguel; Pérez Artieda, Miren Gurutze; Astrain Ulibarrena, David; Institute of Smart Cities - ISC
Despite being one of the largest renewable sources, geothermal energy is not widely utilized for electricity generation. In order to leverage shallow hot dry rock (HDR) fields, the present paper proposes an alternative to enhanced geothermal systems (EGS): thermoelectric generators. Based on the conditions of Timanfaya National Park, a prototype has been built to experimentally analyze the feasibility of the proposed solution. The prototype is composed by a two phase closed thermosyphon (TPCT) as hot side heat exchanger, two thermoelectric modules, and it considers different cold side heat exchangers: fin dissipators assisted by a fan and loop thermosyphons, both with various geometries. Experiments have demonstrated that loop thermosyphons represent the best alternative due to their low thermal resistance and, especially, due to their lack of auxiliary consumption, leading to a maximum net power generation of 3.29 W per module with a temperature difference of 180 °C (200 °C in the hot side and 20 °C as ambient temperature), 54% more than with fin dissipators. Hence, there exists a new opportunity for electricity generation in shallow hot dry rock fields: thermoelectric generators with biphasic thermosyphons as heat exchangers, a patented and robust solution.
Open Access
Energía sostenible: sin malos humos
(Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, 2019) Samanes Pascual, Javier; Pascual Miqueleiz, Julio María; Berrueta Irigoyen, Alberto; Araiz Vega, Miguel; Catalán Ros, Leyre; Aranguren Garacochea, Patricia; Arricibita de Andrés, David; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniería; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Ingeniaritza
¿Puede España ser sostenible energéticamente? Si alguna vez te has planteado esta pregunta, o quieres saber en qué gastamos la energía y de dónde podría ser obtenida, aquí encontrarás respuestas. Nuestros recursos renovables son inmensos, pero también lo es nuestro consumo. Este libro no solo se centra en analizar la situación actual y las posibilidades que las energías renovables tienen en nuestro país, sino que, presentando de forma clara los datos sobre nuestro gasto energético, permite a cada lector identificar sus mayores consumos, de tal forma que pueda considerar cómo reducirlos. Energía sostenible. Sin malos humos es la adaptación al caso español, actualizando los datos, del libro publicado hace una década por David MacKay en el Reino Unido. La sostenibilidad es hoy en día una preocupación creciente en la sociedad. Pero a menudo este interés se ve contaminado por cifras enormes que resultan muy complicadas de comprender. Además, todos hemos oído hablar en algún momento sobre pequeños gestos al alcance de nuestra mano que podrían permitir un cambio hacia un modelo sostenible. Nada más lejos de la realidad, pequeñas acciones solo permiten pequeños cambios, y el cambio de modelo energético al que nos enfrentamos requiere grandes acciones. Para deshacernos de todo este ruido, en este libro se presentan los números de forma clara y sencilla, utilizando unidades a nuestro alcance y que son comprensibles por todas las personas. Esto permite identificar de una forma mucho más personal los consumos energéticos de nuestro día a día. A lo largo de la primera parte del libro se van construyendo dos columnas: una de color rojo, que representa la agregación de consumos, y otra de color verde, que representa la capacidad de generación. Estas columnas ofrecen una comparación muy visual de la infraestructura renovable que sería necesaria para mantener nuestro ritmo de consumo energético actual. Además, utiliza números «gordos» obtenidos de la experiencia del día a día. Por ejemplo, para calcular la capacidad de generación eólica se parte de una velocidad de viento estimada a partir de la velocidad típica de un ciclista urbano. Toda esta información se encuentra en la primera parte del libro, en los capítulos del 1 al 18. Sin embargo, este libro no se centra únicamente en el análisis de la situación actual, sino que da un paso más y propone alternativas al modelo energético actual con el fin de alcanzar un modelo 100% renovable a medio plazo. Estas medidas incluyen un aumento importante en la potencia renovable instalada, un aumento en la eficiencia energética y algunos ligeros cambios en nuestro estilo de vida que permitan una reducción del consumo. Por supuesto, los tres frentes deben ser atacados al mismo tiempo. Estas propuestas se recogen en la segunda parte del libro, en los capítulos 19 a 32. Por último, este es un libro divulgativo al alcance de todas las personas, que busca transmitir toda la información de forma clara e intuitiva sin perderse en complicados cálculos. Pero si eres de los que les gustan las cuentas, al final del libro encontrarás un apartado en el que se explica de forma rigurosa muchos de los cálculos simples realizados en las primeras partes del libro. Estos apéndices técnicos forman la tercera parte del libro, son los apéndices de la A hasta la H.