Open Access
Superbackscattering antenna arrays
(IEEE, 2015) Liberal Olleta, Íñigo; Ederra Urzainqui, Íñigo; Gonzalo García, Ramón; Ziolkowski, Richard W.; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
This article discusses the theory, design and practical implementation of superbackscattering antenna arrays. In analogy with Uzkov’s maximal directivity theorem, it is demonstrated that the maximal backscattering cross-section, normalized to the wavelength squared, of a linear array of N isotropic scatterers whose separation tends to zero is N2(N + 1)2=(4pi). This analytical result is validated via numerical optimization of the excitation coefficients, and the same procedure is utilized to assess the maximal backscattering of arrays of electric Hertzian dipoles (EHDs). It is found that electrically small arrays of two and three EHDs can enhance the backscattering by factors of 6.22 and 22.01, respectively, with respect to the maximum value generated by a single element. In addition, physical realizations of arrays featuring comparable enhancement factors can be straightforwardly designed by using a simple procedure inspired by Yagi-Uda antenna concepts. The practical implementations of such arrays based on copper wires and printed circuit technologies is also addressed.
Open Access
Decoupling of multifrequency dipole antenna arrays for microwave imaging applications
(Hindawi Publishing Corporation, 2010) Sáenz Sáinz, Elena; Guven, K.; Ozbay, Ekmel; Ederra Urzainqui, Íñigo; Gonzalo García, Ramón; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
The mutual coupling between elements of a multifrequency dipole antenna array is experimentally investigated by S-parameter measurements and planar near-field scanning of the radiated field. A multifrequency array with six dipoles is analyzed. In order to reduce the coupling between dipoles, a planarmetasurface is placed atop the array acting as superstrate. Themutual coupling of the antenna elements in the absence and presence of the superstrate is presented comparatively. Between 3 and 20 dB mutual coupling reduction is achieved when the superstrate is used. By scanning the field radiated by the antennas and far-field measurements of the radiation pattern, it is observed that the superstrate confines the radiated power, increases the boresight radiation, and reduces the endfire radiation.
Open Access
Quantum antenna arrays: the role of quantum interference on direction-dependent photon statistics
(American Physical Society, 2018) Liberal Olleta, Íñigo; Ederra Urzainqui, Íñigo; Ziolkowski, Richard W.; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
We investigate the role of quantum interference phenomena on the characteristics of the fields radiated by an array of quantum emitters. In analogy to, but distinct from, classical outcomes, we demonstrate that the array geometry empowers control over direction-dependent photon statistics of arbitrary order. Our formulation enables the recognition of configurations providing spatial correlations with no classical counterpart. For example, we identify a system in which the angular distribution of the average number of photons is independent of the number and position of the emitters, while its higher-order photon statistics exhibit a directional behavior. These results extend our understanding of the fields generated by ensembles of quantum emitters, with potential applications to nonclassical light sources.
Open Access
Advanced feeds for mm-wave antenna systems
(Springer, 2018) Teniente Vallinas, Jorge; Iriarte Galarregui, Juan Carlos; Ederra Urzainqui, Íñigo; Gonzalo García, Ramón; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
Millimeter-wave antenna systems have traditionally required high performance feeds in order to fulfill its stringent requirements. Therefore, this goal has been achieved by corrugated horns. However, in the last years new applications mainly in the communication systems have driven the use of other types of antenna feed with slightly reduced performance but simpler manufacturing at mm-wave and submm-wave frequencies with improvements in cost reduction. These advanced profiles are usually based in smooth waveguide advanced profiles. Besides, the chapter describes different feed configurations based on metamaterial structures and several examples of metamaterial based or inspired antennas are considered. Then, this chapter covers the different alternatives currently used for mm-wave antenna feed: corrugated horns, spline horns, and metamaterial horns. At the end of each section, it includes some research successful results.
Open Access
A millimeter-wave 4th-harmonic Schottky diode mixer with integrated local oscillator
(MDPI, 2021) Pérez Escudero, José Manuel; Quemada Mayoral, Carlos; Gonzalo García, Ramón; Ederra Urzainqui, Íñigo; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
In this paper the design and experimental validation of a fourth-harmonic mixer based on Schottky diodes working around 300 GHz is presented. The main novelty of this work consists in the integration of an MMIC-based local oscillator, working around 75 GHz, and a mixer in the same metallic block housing. A prototype has been characterized using the Y-Factor method and yields a best measured conversion loss and an equivalent noise temperature of 14 dB and 9600 K, respectively. This performance is comparable to the state-of-the-art for this type of mixer.
Open Access
A gap waveguide-based compact rectangular waveguide to a packaged microstrip inline transition
(MDPI, 2020) Pérez Escudero, José Manuel; Torres García, Alicia E.; Gonzalo García, Ramón; Ederra Urzainqui, Íñigo; Institute of Smart Cities - ISC
In this paper two different simple to design and easy to manufacturing transitions from a microstrip to rectangular waveguide based on ridge and groove gap waveguides are studied. The first one is based on a combination of a groove and ridge gap waveguide. In this case, the microstrip substrate occupies the whole bottom metallic housing block, namely, the transition and the gap between the bed of nails and the lid; therefore, it does not require any substrate shaping. Nevertheless, the transition needs to replace groove waveguide by ridge gap waveguide sections to avoid higher-order mode excitation. In the second approach, based on only a groove gap waveguide, the substrate is shaped to be only in the microstrip section, that is, outside the bed of nails area. This leads to a simplification of the design procedure. Prototypes of both transitions have been characterized, showing good agreement with the simulations taking into account the manufacturing tolerances. Performance comparable to the state-of-the-art in this frequency band has been achieved.
Embargo
Experimental validation of a Ku-band dual circularly polarized metasurface antenna
(IEEE, 2018) Tellechea Pereda, Amagoia; Caminita, Francesco; Martini, Enrica; Ederra Urzainqui, Íñigo; Teniente Vallinas, Jorge; Iriarte Galarregui, Juan Carlos; Gonzalo García, Ramón; Maci, Stefano; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica
The experimental validation of a Ku-band dual circularly polarized (CP) broadside-beam metasurface (MTS) antenna is presented. A radially modulated anisotropic single layer MTS has been synthesised employing sub-wavelength elliptical slotted metallic patches printed on top of a thin Arlon grounded substrate. In the structure, two decoupled phasematched transverse magnetic and transverse electric surface waves (SWs) are excited, which interact with the modulated surface leading to a CP broadside radiation. Two different orthomode transducers have been designed to excite the SWs with orthogonal polarization and equal amplitude. The first feeding system is composed of a metallic stepped septum inside an airfilled square waveguide. A conical section is included to match the output port of the square waveguide with the terminal, dielectric filled circular waveguide. The second feed is much more compact and efficient and it is composed of a circular waveguide completely filled by a dielectric. Depending on the input port excited on the feeds, two TE11 modes are excited with ±90° phase shift, which determine the right-hand or left-hand sense of the broadside beam generated by the MTS. Manufacturing details of the MTS and excitations are given and the measurements are compared with the simulation results. Finally, conclusions are drawn.
Open Access
Least upper bounds of the powers extracted and scattered by bi-anisotropic particles
(IEEE, 2014) Liberal Olleta, Íñigo; Ra'di, Younes; Gonzalo García, Ramón; Ederra Urzainqui, Íñigo; Tretyakov, Sergei A.; Ziolkowski, Richard W.; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
The least upper bounds of the powers extracted and scattered by bi-anisotropic particles are investigated analytically. A rigorous derivation for particles having invertible polarizability tensors is presented, and the particles with singular polarizability tensors that have been reported in the literature are treated explicitly. The analysis concludes that previous upper bounds presented for isotropic particles can be extrapolated to bianisotropic particles. In particular, it is shown that neither nonreciprocal nor magnetoelectric coupling phenomena can further increase those upper bounds on the extracted and scattered powers. The outcomes are illustrated further with approximate circuit model examples of two dipole antennas connected via a generic lossless network.
Open Access
Fe-rich ferromagnetic wires for self-sensing materials
(IEEE, 2012) Liberal Olleta, Íñigo; Ederra Urzainqui, Íñigo; Gonzalo García, Ramón; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
The possibility of using Fe-rich wires in mechanical stress self-sensing materials is investigated. To this end, a retrieval technique aimed to characterize the high-frequency magnetoimpedance effect in ferromagnetic wires under mechanical stresses is proposed. The technique is based on the measurement of the wires inside a metallic rectangular waveguide, and it is validated through numerical simulations and tested with already published experimental data. In addition, the studied Fe-rich wires are characterized by the occurrence of the natural ferromagnetic resonance, whose frequency position increases from 7 GHz to 8.25 GHz for elongations ranging from 0 μm to 60 μm.
Open Access
Silicon integrated subharmonic mixer on a photonic-crystal platform
(IEEE, 2021) Torres García, Alicia E.; Pérez Escudero, José Manuel; Teniente Vallinas, Jorge; Gonzalo García, Ramón; Ederra Urzainqui, Íñigo; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
This paper presents a planar silicon integrated subharmonic mixer on top of a photonic-crystal platform. The local oscillator (LO) power is injected through a 2D photoniccrystal (PC) slab to a resonant cavity that effectively couples the signal to a planar bow-tie antenna. The same antenna, which is printed on the top of the PC cavity, contains an antiparallel Schottky diode pair which performs the down-conversion. The proposed design is a simple, easy to integrate, low cost, low profile device. Moreover, the described fabrication process is compatible with active components integration. The performance of the design has been experimentally demonstrated showing good agreement with the simulation and is comparable with the stateof-the-art of planar mixers. The work presented here is based on concepts and technologies from electronics and photonics domains and may be a good starting point for the creation of new devices, allowing the integration and upgrading of existing techniques from both worlds.