Person: Pascual Miqueleiz, Julio María
Loading...
Email Address
Birth Date
Research Projects
Organizational Units
Job Title
Last Name
Pascual Miqueleiz
First Name
Julio María
person.page.departamento
Ingeniería Eléctrica y Electrónica
ORCID
0000-0002-9495-5910
person.page.upna
810225
Name
7 results
Search Results
Now showing 1 - 7 of 7
Publication Open Access Fuzzy-based power exchange management between grid-tied interconnected residential microgrids(IEEE, 2020) Arcos Avilés, Diego; García Gutiérrez, Gabriel; Guinjoan Gispert, Francesc; Ayala, Paúl; Ibarra, Alexander; Motoasca, Emilia; Llanos, Jacqueline; Pascual Miqueleiz, Julio María; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio IngeniaritzarenThis paper presents a fuzzy-based power exchange management between two neighboring residential grid-connected microgrids comprising both photovoltaic generation and battery energy storage system (BESS). The proposed power exchange management accounts for the magnitude of the energy rate-of-change of each microgrid and the charge difference between the BESSs of both microgrids to charge the ESS that has an energy deficit. As such, the proposed power exchange management can reduce the amount of power absorbed from the mains of each microgrid by operating jointly with each other rather than separately, and it also synchronizes the ESS of both microgrids, improving the behavior of ESSs. A comparison of the simulated results for a scenario with and without power exchange is presented in order to demonstrate the adequate behavior of the proposed power exchange management.Publication Open Access Energy management for an electro-thermal renewable based residential microgrid with energy balance forecasting and demand side management(Elsevier, 2021) Pascual Miqueleiz, Julio María; Arcos Avilés, Diego; Ursúa Rubio, Alfredo; Sanchis Gúrpide, Pablo; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio IngeniaritzarenThis paper proposes an energy management strategy for a residential microgrid comprising photovoltaic (PV) panels, a small wind turbine and solar thermal collectors. The microgrid can control the power exchanged with the grid thanks to a battery and a controllable electric water heater, which provide two degrees of freedom to the control strategy. As input data, the proposed control strategy uses the battery state of charge (SOC), the temperature of the hot water tank, the power of each microgrid element as well as the demand and renewable generation forecasts. By using forecasted data and by controlling the electric water heater, the strategy is able to achieve a better grid power profile while using a smaller battery than previous works, hence reducing the overall cost of the system. The strategy is tested by means of simulation with real data for one year and it is also experimentally validated in the microgrid built at the Renewable Energy Laboratory at the UPNA.Publication Open Access Long-term degradation rate of crystalline silicon PV modules at commercial PV plants: an 82-MWp assessment over 10 years(Wiley, 2021) Pascual Miqueleiz, Julio María; Martínez Moreno, Francisco; García Solano, Miguel; Marcos Álvarez, Javier; Marroyo Palomo, Luis; Lorenzo Pigueiras, Eduardo; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de ComunicaciónDue to high competitiveness in the PV sector, despite the low degradation rate of crystalline silicon PV modules (below 0.5%/year), it is still important for utilities to know its actual value due to its impact on energy yield and hence, profitability, over the lifetime of a PV plant. However, uncertainties related to both the influence of downtime periods due to problems that may appear under normal operation of a commercial PV plant and to the measurement of degradation rates at PV plant level make this a challenging task. In order to obtain a significant value, in this paper, three measuring methods with different uncertainty sources are used for 82 MWp of PV modules on different locations in Spain and Portugal over 10 years. According to the different methods used and PV plants analyzed, excluding PV plants with problems, a range of degradation rates between 0.01 and 0.47%/year has been found. The overall average value observed is 0.27%/year. The findings of this work have also revealed the great importance of good operation and maintenance practices in order to keep overall low degradation rates.Publication Open Access In-field energy performance of solar PV module made of UMG silicon(IEEE, 2022) Guerra, Moisés R.; Parra Laita, Íñigo de la; García Solano, Miguel; Pascual Miqueleiz, Julio María; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de ComunicaciónUpgraded metallurgical grade silicon (UMG-Si) PV modules have failed to make their space in the PV market, which was partly to the uncertainty on their in-field performance that brings the wide disparity of results published over the years. The most-recently developed UMG-Si PV modules have demonstrated similar initial degradation and efficiencies under standard test conditions (STC) to those obtained with conventional solar grade silicon (SoG-Si). Nevertheless, their performance under operating conditions other than STC and its impact on the energy production are key aspects that have not yet been properly characterized in the literature. This article analyzes the in-field performance of a PV generator comprised of recently developed UMG-Si modules. This performance was compared to that of another PV generator comprising standard polysilicon modules. The cells and modules of both types of generators were made by the same manufacturer in the same period and on the same production lines, which guarantees that performance differences encountered are exclusively due to the silicon employed. Contrary to the previous experience, this article reveals that UMG-Si modules do not necessarily present a better temperature performance than today's conventional modules. The analyzed UMG-Si modules presented 1.6% less efficiency under low irradiance conditions, but this different irradiance performance led to an insignificant difference (less than 0.5%) in their energy production. No significant degradation was measured in both UMG-Si and SoG-Si modules during the two-year analyzed period, being the final energy performance of both types of modules essentially the same. These results can be considered as highly representative of the current state-of-the-art of UMG-Si technology.Publication Open Access An energy management system design using fuzzy logic control: smoothing the grid power profile of a residential electro-thermal microgrid(IEEE, 2021) Arcos Avilés, Diego; Pascual Miqueleiz, Julio María; Guinjoan Gispert, Francesc; Marroyo Palomo, Luis; García Gutiérrez, Gabriel; Gordillo, Rodolfo; Llanos, Jacqueline; Sanchis Gúrpide, Pablo; Motoasca, Emilia; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio IngeniaritzarenThis work deals with the design of a Fuzzy Logic Control (FLC) based Energy Management System (EMS) for smoothing the grid power prole of a grid-connected electro-thermal microgrid. The case study aims to design an Energy Management System (EMS) to reduce the impact on the grid power when renewable energy sources are incorporated to pre-existing grid-connected household appliances. The scenario considers a residential microgrid comprising photovoltaic and wind generators, at-plate collectors, electric and thermal loads and electrical and thermal energy storage systems and assumes that neither renewable generation nor the electrical and thermal load demands are controllable. The EMS is built through two low-complexity FLC blocks of only 25 rules each. The first one is in charge of smoothing the power prfile exchanged with the grid, whereas the second FLC block drives the power of the Electrical Water Heater (EWH). The EMS uses the forecast of the electrical and thermal power balance between generation and consumption to predict the microgrid behavior, for each 15-minute interval, over the next 12 hours. Simulations results, using real one-year measured data show that the proposed EMS design achieves 11.4% reduction of the maximum power absorbed from the grid and an outstanding reduction of the grid power profile ramp-rates when compared with other state-of-the-art studies.Publication Open Access Analysis of polyamide and fluoropolymer backsheets: Degradation and insulation failure in field-aged photovoltaic modules(John Wiley & Sons, 2022) Pascual Miqueleiz, Julio María; García Solano, Miguel; Marcos Álvarez, Javier; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate PublikoaDurability of photovoltaic (PV) modules is of great concern not only from the point of view of cost-effectiveness but also from the point of view of safety and sustainability. The backsheet of a PV module is one of the most critical parts of the PV module from the point of view of protection and also one of the most important sources of PV modules' failure; hence, it is of great importance to understand its different forms of failure. In this paper we analyze the case of an 8-MW PV plant, which had suffered a rapid degradation of their PV modules' backsheets. The case is especially relevant as all the PV modules are from the same model and manufacturer but with different backsheet materials (polyamide and fluoropolymer) and different times of exposure: on one hand, all PV modules originally installed in the plant (i.e., 6 years under operation when tested), and also, extra modules that had been stored indoors for replacement and had been mounted in the plant for less than 1 year when tested, serving as reference modules. In this paper we present the signs of degradation of these PV modules after different times of exposure under real operation using different on-field and laboratory tests. We propose different techniques for rapid diagnosis of backsheet degradation so that the problem can be detected at a very early stage, before it results in major energy losses or in safety issues.Publication Open Access Development of energy management strategies for the sizing of a fast charging station for electric buses(IEEE, 2020) Ojer Palacios, Iñaki; Berrueta Irigoyen, Alberto; Pascual Miqueleiz, Julio María; Sanchis Gúrpide, Pablo; Ursúa Rubio, Alfredo; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Gobierno de Navarra / Nafarroako Gobernua, 0011–1411–2018–000029 GERA; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, ReBMS PJUPNA1904The electric vehicle contributes to reduce greenhouse gases emissions and get a greater integration of renewable energy. In this context, the implementation of urban buses implies the development of new grid infrastructures in order to carry out the electricity supply required by the charging stations. In order to optimize the size of these infrastructures and to have more power capacity, this contribution proposes the design and the sizing of a fast charging station with a stationary energy storage system (ESS) installed, to supply the energy of the buses that run on one of the lines of Pamplona (Spain). In this contribution, first, the power demanded by the charging point is measured at the fast charging station located at the Public University of Navarre. Second, three energy management strategies are developed with which to use ESS. Finally, the proposed energy management strategies are simulated with the measured data obtained. The results achieved in this contribution show that with a 40 kWh ESS, the power demanded from the grid can be reduced by a whole 70%, that is, from 250 kW to 74 kW. In addition, the power contracted in the electricity rate is reduced too.