Open Access
Mode transitions and thickness measurements during deposition of nanoscale TiO2 coatings on tilted fiber Bragg gratings
(IEEE, 2022) Imas González, José Javier; Albert, Jacques; Del Villar, Ignacio; Ozcariz Celaya, Aritz; Ruiz Zamarreño, Carlos; Matías Maestro, Ignacio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
The mode transition is a phenomenon observed in thin film coated long period fiber gratings (LPGs) and singlemode multimode single-mode (SMS) fibers for certain values of the coating thickness and refractive index, resulting in increased sensitivity for sensing applications. It is shown here that mode transitions occur simultaneously for a large number of mode resonances in the transmission spectra of tilted fiber Bragg gratings (TFBG) measured during the deposition of ~350nm thick TiO2 coatings by Atomic Layer Deposition (ALD). In TFBGs, the mode transition shows up as an acceleration of the resonance wavelength shift vs thickness, but without fading of the resonance amplitude. Furthermore, the results show that the mode transition for cladding modes with predominantly “TE” polarization at the cladding boundary is significantly sharper than that of predominantly “TM” polarized modes and that it occurs at a smaller coating thickness (<100 nm vs >200 nm). Finally, using a separately determined coating refractive index (2.14, by ellipsometry on witness flats deposited simultaneously) and simulations of the resonance shifts of the TFBG with coating thickness, it is demonstrated that a TFBG connected to a spectral interrogation system can be used to measure the growth of a coating on the surface of the fiber in real time.
Open Access
Generation of lossy mode resonances with absorbing thin-films
(IEEE, 2010) Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Hernáez Sáenz de Zaitigui, Miguel; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
The generation of lossy mode resonances with absorbing thin-films is analyzed with electromagnetic theory. The main differences with surface plasmon resonances are presented and some rules are given towards an optimum design of sensing devices based on absorbing thin-film coated silica substrates. The material selected for the absorbing thin-film is ITO, which is adequate for supporting both surface plasmon resonances and lossy mode resonances.
Open Access
D-shape optical fiber pH sensor based on lossy mode resonances (LMRs)
(IEEE, 2016-01-07) Zubiate Orzanco, Pablo; Ruiz Zamarreño, Carlos; Del Villar, Ignacio; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza
The fabrication and characterization of an optical fiber pH sensor based on Lossy Mode Resonances (LMRs) is presented. PAH/PAA polymeric thin-films fabricated onto side-polished D-shaped optical fibers are used as LMR supporting coatings. The thickness of PAH/PAA coatings can be modified as a function of the external medium pH. As a consequence of this variation, the effective refractive index of the structure will change, producing a shift of the LMR. The fabricated sensor has been used to measure pH from 4.0 to 5.0. This pH sensor showed a sensitivity of 101.3 nm per pH unit, which means a resolution of ~6×10-4 pH units by using a conventional communications Optical Spectrum Analyzer (OSA), which is an improvement over commercial pH sensors.
Open Access
Generation of surface plasmon resonance and lossy mode resonance by thermal treatment of ITO thin-films
(Elsevier, 2014) Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Hernáez Sáenz de Zaitigui, Miguel; Sánchez Zábal, Pedro; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
Silicon wafers coated with IndiumTinOxide (ITO) by application of sputtering technique have been characterized after different post-annealing techniques, showing that this last factor is critical for the quality of the thin-film and for the creation and tuning of both surface plasmon resonances and lossy mode resonances. By adequate selection of the ITO thin-film thickness both resonances can be tracked in the same spectrum, which can be used in sensor and optical communications fields.
Open Access
Ultra-low detection limit lossy mode resonance-based fibre-optic biosensor
(Optica Publishing Group, 2018) Chiavaioli, Francesco; Zubiate Orzanco, Pablo; Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Giannetti, Ambra; Tombelli, Sara; Trono, Cosimo; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Baldini, Francesco; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
We report on ultra-low detection limit lossy mode resonance-based fibre-optic biosensor coated with nm-thick tin dioxide film, which allows measuring fibre-surrounding medium changes with very high sensitivity for label-free and real-time biomolecular interaction analysis
Open Access
Design rules for lossy mode resonance based sensors
(Optical Society of America, 2012) Del Villar, Ignacio; Hernáez Sáenz de Zaitigui, Miguel; Ruiz Zamarreño, Carlos; Sánchez Zábal, Pedro; Fernández Valdivielso, Carlos; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Gobierno de Navarra / Nafarroako Gobernua
Lossy mode resonances can be obtained in the transmission spectrum of cladding removed multimode optical fiber coated with a thin-film. The sensitivity of these devices to changes in the properties of the coating or the surrounding medium can be optimized by means of the adequate parameterization of the coating refractive index, the coating thickness and the surrounding medium refractive index (SMRI). Some basic rules of design, which enable the selection of the best parameters for each specific sensing application, are indicated in this work.
Open Access
Generation of lossy mode resonances by deposition of high-refractive-index coatings on uncladded multimode optical fibers
(IOP Publishing Ltd, 2010) Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Sánchez Zábal, Pedro; Hernáez Sáenz de Zaitigui, Miguel; Fernández Valdivielso, Carlos; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
A comparative study of lossy mode resonances generated by depositing two different materials is presented. The two materials selected are indium tin oxide (ITO) and indium oxide. The two materials present different dielectric dispersion, which leads to the generation of single-peak lossy mode resonances with the ITO coated optical fibers and dual-peak lossy mode resonances with the In2O3 coated optical fibers. The obvious advantage of a dual-peak based measurement in the sensors field is enhanced by a sensitivity increase observed in sensors based on In2O3 if compared with those based on ITO. These characteristics are analyzed both theoretically and experimentally.
Open Access
An antibacterial coating based on a polymer/sol-gel hybrid matrix loaded with silver nanoparticles
(Springer, 2011) Rivero Fuente, Pedro J.; Urrutia Azcona, Aitor; Goicoechea Fernández, Javier; Ruiz Zamarreño, Carlos; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work a novel antibacterial surface composed of an organic-inorganic hybrid matrix of tetraorthosilicate and a polyelectrolyte is presented. A precursor solution of tetraethoxysilane (TEOS) and poly(acrylic acid sodium salt) (PAA) was prepared and subsequently thin films were fabricated by the dip-coating technique using glass slides as substrates. This hybrid matrix coating is further loaded with silver nanoparticles using an in situ synthesis route. The morphology and composition of the coatings have been studied using UV-VIS spectroscopy and atomic force microscopy (AFM). Energy dispersive X-ray (EDX) was also used to confirm the presence of the resulting silver nanoparticles within the thin films. Finally the coatings have been tested in bacterial cultures of genus Lactobacillus plantarum to observe their antibacterial properties. It has been experimentally demonstrated that these silver loaded organic-inorganic hybrid films have a very good antimicrobial behavior against this type of bacteria.
Open Access
Improving the width of lossy mode resonances (LMRs) in double-clad fibers
(IEEE, 2023) Imas González, José Javier; Del Villar, Ignacio; Zubiate Orzanco, Pablo; Ruiz Zamarreño, Carlos; Matías Maestro, Ignacio; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
In this work, the characteristics of lossy mode resonances (LMRs) in double-clad fibers where the refractive index (RI) of the second cladding is lower than that of the first cladding are analyzed both numerically and experimentally. In the first place, the LMRs spectra obtained with a 75 nm TiO 2 thin film are simulated, and it is observed that a thicker second cladding improves the width of the resonances, making them narrower. Then, two experimental cases (no second cladding, and second cladding with thickness of 1.13 μm) are assessed, showing a good agreement with the previous simulations. Finally, an experimental refractometric study is carried out in liquids (surrounding medium refractive index in the 1.34 - 1.40 range) for both fibers, calculating the full width at 1 dB (FW 1dB ), the sensitivity, and the figure of merit (FOM). The FW 1dB is better for the LMR obtained on the fiber with second cladding while the sensitivity is slightly greater for the fiber without second cladding. In the case of the FOM, it is higher for the double-clad fiber as the narrowing of the resonances outweighs the lower sensitivity. These results show that the performance of LMR-based optical fiber sensors can be improved by employing double-clad fibers.
Open Access
Generation of lossy mode resonances (LMR) using perovskite nanofilms
(Chinese Academy of Sciences, 2024) Armas, Dayron; Matías Maestro, Ignacio; López-González, M. Carmen; Ruiz Zamarreño, Carlos; Zubiate Orzanco, Pablo; Del Villar, Ignacio; Romero, Beatriz; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
The results presented here show for the first time the experimental demonstration of the fabrication of lossy mode resonance (LMR) devices based on perovskite coatings deposited on planar waveguides. Perovskite thin films have been obtained by means of the spin coating technique and their presence was confirmed by ellipsometry, scanning electron microscopy, and X-ray diffraction testing. The LMRs can be generated in a wide wavelength range and the experimental results agree with the theoretical simulations. Overall, this study highlights the potential of perovskite thin films for the development of novel LMR-based devices that can be used for environmental monitoring, industrial sensing, and gas detection, among other applications.