Publication:
Simple modelling of DGS to design 1D-PBG low-pass filters

Date

2003

Director

Publisher

Wiley
Acceso abierto / Sarbide irekia
Artículo / Artikulua
Versión aceptada / Onetsi den bertsioa

Project identifier

Métricas Alternativas

Abstract

The use of defected ground structures (DGS) is being intensively explored by the microwave filter designer community. The DGSs are one possible implementation of a 1D Photonic Band Gap (1D-PBG) where some defect structures are patterned on the ground plane of a microstrip circuit. In this paper, the relation between the behaviour of the DGS structures and the classical microwave filter design theory is established. In particular, a simple model procedure based on the classical microwave filter design theory by using DGS structures is presented. In order to illustrate the method, two low-pass filters are designed, fabricated and measured.

Description

This is the peer reviewed version of the following article: Garde, I., Yábar, M. J. and del Río, C. (2003), Simple modelling of DGS to design 1D-PBG low-pass filters. Microw. Opt. Technol. Lett., 37: 228–232. doi:10.1002/mop.10878, which has been published in final form at http://dx.doi.org/10.1002/mop.10878. This article may be used for non-commercial purposes in accordance with Wiley Terms and Conditions for Self-Archiving.

Keywords

Microstrip filters, Low-pass filters, Defected ground structures (DGS), Photonic band gap structures (PBG)

Department

Ingeniería Eléctrica y Electrónica / Ingeniaritza Elektrikoa eta Elektronikoa

Faculty/School

Degree

Doctorate program

item.page.cita

item.page.rights

© 2003 Wiley Periodicals, Inc.

Los documentos de Academica-e están protegidos por derechos de autor con todos los derechos reservados, a no ser que se indique lo contrario.