Publication: Design and optimization of the dies for the isothermal forging of a cam
Consultable a partir de
Date
Director
Publisher
Project identifier
Abstract
In the present study, the design of the dies required for the isothermal forging of a cam is analysed by finite volume method. Specifically, cams are of great importance in automotive industry, where a lower weight and an improvement in the lubrication or in the materials to be in contact lead to a significant reduction in the fuel cost. The flow stress curves of one Al-Mg alloy were firstly determined by using compression tests. Once these flow stress curves were obtained, FV simulation was employed. In the forging process, the optimum die configuration has been selected. To this end, several aspects have been taken into account such as the force required for the forging, the correct die filling, the introduced plastic strain and the damage imparted to the billet.
Keywords
Department
Faculty/School
Degree
Doctorate program
Editor version
Funding entities
© 2015 Published by Elsevier Ltd. This is an open access article under the CC BY-NC-ND license.
Los documentos de Academica-e están protegidos por derechos de autor con todos los derechos reservados, a no ser que se indique lo contrario.